Raymarine Remote Keypad, User Manual

Page: 16 / 28

10 SeaTalk Remote Keypad Owner’s Handbook
2. Drill the two 5 mm (3/16 in) fixing stud clearance holes (2).
3. Cut out the 45 mm aperture (3), then remove the template.
4. Remove any rough edges from the bulkhead.
5. Peel off the protective sheet from the self-adhesive gasket (4) then
stick the gasket into position on the rear of the instrument.
6. Screw the two fixing studs (1) into the keypad.
7 Offer up the assembled keypad, gasket and studs to the bulkhead,
and plug the SeaTalk cables (6) into the back of the keypad as
shown.
8. Fit the keypad to the bulkhead, by inserting the fixing studs (1)
through the drilled holes (2) and securing with the thumb nuts (5).
Tighten the thumb nuts BY HAND, until the keypad is secure. Do
NOT use a wrench to tighten the nuts.
Connecting to SeaTalk
Connect your SeaTalk Remote Keypad to SeaTalk by plugging the
supplied SeaTalk cable into a convenient 3-Way SeaTalk connector
block.
D2352-5
Daisy-chain or extension cable
Remote Keypad connected to the SeaTalk bus
Power cable
3-way SeaTalk connector block
Autopilot connections
When the associated instrument system is configured for use with an
autopilot, a SeaTalk link between the instrumentation and the course
computer is required.
073_5txt.p65 1/22/2003, 10:07 AM 10