5.7 Initial set up
Unless your radio has been pre-programmed; the first time you power-up your radio you will be
requested to select certain options. With the exception of your MMSI and ATIS ID, you will also be
requested to enter these options after a factory reset.
After acknowledging the startup screen, unless previously set you will be prompted to make the
following selections:
1.
Language selection
— See
for available languages.
2.
Turn on AIS reception (Ray70 and Ray91 only)
— Enables the built-in AIS receiver. This step
is only applicable to radios with a built-in AIS receiver. See
5.9 Switching on the AIS receiver
for more information.
3.
Select network type
— Selects which connection to transmit AIS and DSC information on, to
connected equipment. This step is only applicable if the AIS receiver was turned on in the
previous step. See
for available options.
4.
Enter MMSI number
— Required to enable DSC functions. This option is not required after a
factory reset, or if the radio has been pre-programed in MARCOM-C mode, or has ATIS enabled.
See
for more information. If not already selected you will also be
prompted to select your network type.
5.
Enter ATIS ID
— Required when the radio will be used in the inland waterways of Europe. This
step is only applicable if the radio has been pre-programed in MARCOM-C mode. See
for more information.
6.
Frequency band selection
— Sets the relevant channels for your region. This step is not
applicable if the radio has been pre-programed in MARCOM-C mode. See
for more information.
5.8 Selecting a language
The language the radio uses can be changed.
From the Main menu:
1. Select
Set-up
.
2. Select
Language
.
The languages available are:
•
English (default)
— English
•
Español
— Spanish
•
Français
— French
•
Deutsch
— German
•
Italiano
— Italian
3. Select the language that you want the radio to be set to.
The User interface language is changed to the selected language.
5.9 Switching on the AIS receiver
If your radio includes a built-in AIS receiver then it can be enabled and disabled as follows:
From the Main menu:
1. Select
Set-up
.
2. Select
AIS
.
3. Select
On
to switch the receiver on, or select
Off
to switch the receiver off.
74
