Raymarine Ray 90, Installation And Operation Instruction Manual

Page: 80 / 192

5.7 Initial set up
Unless your radio has been pre-programmed; the first time you power-up your radio you will be
requested to select certain options. With the exception of your MMSI and ATIS ID, you will also be
requested to enter these options after a factory reset.
After acknowledging the startup screen, unless previously set you will be prompted to make the
following selections:
1. Language selection — See 5.8 Selecting a language for available languages.
2. Turn on AIS reception (Ray70 and Ray91 only) — Enables the built-in AIS receiver. This step
is only applicable to radios with a built-in AIS receiver. See 5.9 Switching on the AIS receiver
for more information.
3. Select network type — Selects which connection to transmit AIS and DSC information on, to
connected equipment. This step is only applicable if the AIS receiver was turned on in the
previous step. See
5.10 Selecting a network type for available options.
4. Enter MMSI number — Required to enable DSC functions. This option is not required after a
factory reset, or if the radio has been pre-programed in MARCOM-C mode, or has ATIS enabled.
See
5.11 Entering an MMSI number for more information. If not already selected you will also be
prompted to select your network type.
5. Enter ATIS ID — Required when the radio will be used in the inland waterways of Europe. This
step is only applicable if the radio has been pre-programed in MARCOM-C mode. See 5.12
Entering an ATIS ID for more information.
6. Frequency band selection — Sets the relevant channels for your region. This step is not
applicable if the radio has been pre-programed in MARCOM-C mode. See 5.13 Changing the
radio region for more information.
80