18
I/O Drive - Installation Guide
Figure 17:Fitting the I/O drive unit (KAD 32)
CAUTION:
The fixed and spring-loaded location pins must be fully engaged
in the I/O drive girdle tube. If they are not the autopilot will fail.
5. Fit the pushrod onto the adaptor pin and secure it with the split pin.
6. Complete a hardover to hardover check:
•
Slowly turn the steering system from hardover to hardover.
•
Make sure that the drive unit and adaptor pin bracket do not
come into contact with any part of the engine, boat or steering
system.This includes any engine hoses that may have a
passing contact with the I/O drive unit.
Note: If necessary, you can rotate the main body of the drive unit
relative to the girdle tube (see Figure 18).
Mounting in a restricted area
If an obstruction prevents you from installing the I/O drive unit as
supplied, rotate the main body of the drive relative to the girdle tube
as follows:
1. Remove the two fixing screws on the front cover.
2. Carefully slide the cover forwards, making sure you do not pull
any of the four cables from the plugs inside the cover.
3. Loosen the lock nut.
D5215-1
I/O drive girdle tube
Girdle
support bracket
Pushrod end
All manuals and user guides at all-guides.com
