Note:
Augmented Reality objects will not appear correctly onscreen if the camera
is centered inaccurately.
8.5 Mounting the unit (above surface cabling)
Note:
The camera is supplied partly assembled. The external metallic collar
protects the camera ball when the camera is in use. You must (re)attach
the collar to the camera base after mounting the camera.
Having chosen a suitable location, install the unit as follows:
1. Remove all components from the box.
2. Check the selected location for the unit. A clear, flat area is required,
which is safe to have mounting screws fitted to.
3. Use the supplied mounting template to mark out the location of the
mounting holes.
4. Drill the holes required at the marked locations.
5. Remove the grub screws from the side of the camera’s base using the
supplied hex wrench (Allen key).
6. Disconnect the camera body and collar from the base of the camera.
7. Feed the fitted cable through the camera base’s cable channel.
Example: above surface cabling
8. Peel the adhesive cover off of the waterproof gasket.
9. Align the waterproof gasket underneath the camera’s base with the
mounting screw holes, and attach the gasket onto the camera base.
10. Secure the base in position using the mounting screws provided.
11. Connect the camera’s fitted cable to the relevant power and network
connections.
12. Adjust the position of the ball by hand so that the camera’s green infrared
sensor is centered at the top.
13. Power up the system and check the camera’s video feed.
14. Adjust the position of the ball by hand to obtain the best picture, along
with the collar if your camera’s view is obscured.
15. Align and reinsert the grub screws.
Note:
Augmented Reality objects will not appear correctly onscreen if the camera
is centered inaccurately.
31
