Raymarine AXIOM 2 PRO, Installation Instructions Manual

Page: 51 / 126

9.2 Connections overview — RVM variant
displays
The following connections are available on Axiom® 2 Pro RVM variant
displays:
1. GPS Antenna — The GPS antenna connector enables connection of an
optional external passive GNSS (GPS) antenna (e.g.: GA200 part number
A80589).
2. Accessory — The accessory connector enables connection of an external
card reader such as the RCR-SD/USB (part number A80440).
3. HDMI Out — The Micro HDMI out connector enables connection of an
external HDMI monitor or HDTV using the Micro HDMI (Type D) to HDMI
cable (part number A80723). The monitor mirrors the display’s screen.
4. PWR|Video|Audio — The power/video/audio connector provides a
connection to a 12 / 24 V dc power supply, an analog video input via BNC
connector, and analog audio output via RCA connectors.
5. RV/RVM Transducer — The RV/RVM transducer connection can be used
to connect RealVision™ Max 3D or RealVision™ 3D transducers (also
allows connection of DownVision™, SideVision™ or CPT-S CHIRP conical
beam transducers via an adapter cable).
6. 1kW Transducer — The 1kW transducer connection can be used to
connect CHIRP / Traditional (up to 1kW) transducers.
7. NMEA 2000 — The NMEA 2000 connector enables connection to a
SeaTalkng ® or NMEA 2000 network using the supplied SeaTalkng ® to
DeviceNet adaptor cable or a suitable DeviceNet cable.
8. Network — The 2 x network connectors enable connection of RayNet
devices.
9. Ground — The optional grounding point should only be used when the
display experiences touchscreen interference from nearby equipment.
The grounding point should be connected to the same RF ground point
as the interfering equipment, or the vessel’s negative battery terminal.
9.3 Connections overview — S variant displays
The following connections are available on Axiom® 2 Pro S variant displays:
1. GPS Antenna — The GPS antenna connector enables connection of an
optional external passive GNSS (GPS) antenna (e.g.: GA200 part number
A80589).
2. Accessory — The accessory connector enables connection of an external
card reader such as the RCR-SD/USB (part number A80440).
3. HDMI Out — The Micro HDMI out connector enables connection of an
external HDMI monitor or HDTV using the Micro HDMI (Type D) to HDMI
cable (part number A80723). The monitor mirrors the display’s screen.
4. PWR|Video|Audio — The power/video/audio connector provides a
connection to a 12 / 24 V dc power supply, an analog video input via BNC
connector, and analog audio output via RCA connectors.
5. Transducer — The transducer connection can be used to connect a
CPT-S CHIRP conical beam transducer via an adapter cable.
Cables and connections — General information 51