Raymarine a9 Series, Mounting And Getting Started, Page: 10 / 20

1. Carefully lift one edge of the screen protection
film, so that it is accessible for removing when unit
installation is complete.
2. Ensure the memory card slot door is in the open
position.
3. Orientate the bottom-right side of the bezel under the
lip of the chart card door and place the bezel over
the front of the display, ensuring that the clips along
the bottom edge of the bezel latch into position.
D 12586-1
4. Ensure the bezel is correctly aligned with the display,
as shown.
5. Apply firm but even pressure to the bezel along the:
i. Outer edges - work from the sides upwards and
then along the top edge, to ensure that it clips
securely into position.
ii. Inner edges - particularly along the chart card
door edge, to ensure that the bezel sits flat.
6. Check that the Power button and chart card door
are free to operate.
Removing the front bezel
Before proceeding ensure the memory card slot door
is open.
D 12584-1
0
1 1
2 2 2 2
1
2
1
2
1
2
1
2
Important: Use care when removing the bezel. Do
not use any tools to lever the bezel; doing so may
cause damage.
1. Place both your thumbs on the upper left edge of
the display, at the positions indicated in the diagram
above.
2. Place your fingers underneath the bezel, at the
positions indicated in the diagram above.
3. In a single firm motion, apply pressure to the outer
edge of the display with your thumbs and pull the
bezel towards you using your fingers.
The bezel should now come away from the display
easily.
a9x and a12x connections overview
The a9x and a12x variant MFDs include the following
connections.
D13068-1
1 2 3 4 5 6
1. Sonar transducer (a97 and a127) / DownVision TM
transducer (a98 and a128)
2. SeaTalk ng
3. Network 1 (RayNet)
4. Network 2 (RayNet)
5. Power and data
6. GA150 antenna
Power and data connection
The details below apply to MFDs which have a
combined power and data cable.
D12250-2
2
1
4 5
7
3
8
6
9
1. Power and data connection
2. Power and data cable
10 a9x / a12x