7
Installation Instructions
H910 End Seal (for tee connections only)
Note: The end seal is designed to be installed only once; it cannot be removed from the heating cable once installed. Do not use until ready
for final installation.
1
End Seal for H612 and H622
1
End Seal for H311, H611, and H621
2
2
3
3
4
• Remove the outer jacket.
• Do not cut or damage inner jacket.
• Push the braid back 2 inches from the
cable end.
• Slide the braid up against the end seal and secure
with the 6-inch length of tape provided.
• Firmly push end seal onto the cable (at least 1 1/2 inches).
Some gel may ooze out.
• Do not twist or try to remove the end seal during or after
insertion. Do not reuse an end seal.
• Firmly push end seal onto the cable (at least 1 1/2 inches).
Some gel may ooze out.
• Do not twist or try to remove the end seal during or after
insertion. Do not reuse an end seal.
• Unravel and remove
exposed braid.
• Cleanly cut off the end of the cable.
• Score down and around outer
jacket 1 inch from the end.
• Cleanly cut off the end of the cable.
