©
2007
Tyco
Thermal
Controls
Printed
in
USA
P/N
585033
H55073
01/07
Worldwide Corporate Headquarters
Tyco Thermal Controls
2415 Bay Road
Redwood City, CA 94063-3032
Tel: (800) 545-6258
Tel: (650) 216-1526
Fax: (800) 527-5703
Fax: (650) 474-7711
www.tycothermal.com
Important:
All information, including illustrations, is believed to be reliable. Users, however,
should independently evaluate the suitability of each product for their particular application.
Tyco Thermal Controls makes no warranties as to the accuracy or completeness of the informa-
tion, and disclaims any liability regarding its use. Tyco Thermal Controls' only obligations are
those in the Tyco Thermal Controls Standard Terms and Conditions of Sale for this product,
and in no case will Tyco Thermal Controls or its distributors be liable for any incidental, indi-
rect, or consequential damages arising from the sale, resale, use, or misuse of the product.
Specifications are subject to change without notice. In addition, Tyco Thermal Controls reserves
the right to make changes — without notification to Buyer — to processing or materials that
do not affect compliance with any applicable specification.
Tyco, Raychem and WinterGard are trademarks of Tyco Thermal Controls LLC or its affiliates.
Canada
Tyco Thermal Controls
250 West St.
Trenton, Ontario
Canada K8V 5S2
Tel: (800) 545-6258
Fax: (800) 527-5703
2
• Push the braid back 2 inches from the cable end.
• Cleanly cut off the end of the cable.
• Firmly push end seal onto the cable (at least 1½ inch).
Some gel may ooze out.
• Do not twist or try to remove the end seal during or after
insertion.
• Do not reuse an end seal.
3
4
• Slide the braid up against the end seal and secure with the
6-inch length of tape provided.
H910 Installation Instructions
1
End Seal Installation Instructions for H311, H611 and H621 Heating Cables
Note:
The end seal is designed to be installed only once. It cannot be removed from the heating cable once it is installed. Do not install it until instructed to
do so in Step 3
