15
ENGLISH
INSTRUCTION MANUAL
Introduction
To get the most out of your new amplifier, please
read through these instructions before use. We
also recommend that you save the instructions in
case you need to refer to them at a later date.
Technical data
2 × 200 W
2 channels
Option for bridge circuit
Signal-to-noise-ratio: = 80 dB
Frequency range: 10 Hz -30 KHz
Main components
1. Signal inputs, phono
2. Indicator
3. „Gain“ button for setting input sensitivity
4. Bass adjustment button
5. Treble adjustment button
6. Speaker outputs
7. Fuse
8. 12 V-clamps and control clamp
Special safety instructions
Do not set the volume so high that you can no
longer safely move around in traffic or hear any
warning signals from ambulances, other road users
and from level crossings, etc.
The amplifier may become very hot when in use
and therefore the unit must be adequately
ventilated. Do not touch the amplifier and keep
any flammable substances away from it when in
use.
It is advisable to only use the amplifier when the
engine is running, as the battery will otherwise run
down quickly.
Make sure that the amplifier and cables do not
interfere with operation of the car and are not
exposed to liquids, heat, impacts, knocks or any
other mechanical effects.
If the amplifier’s fuse blows, it must be replaced
with a new fuse with the same properties.
The amplifier is intended for speakers with an
impedance of 2-8 ohm. Check that the car’s
speakers can support the amplifier’s output before
installing.
1
2
3
4
5
6
7
8
