Ravendo 164014, User Manual, Page: 7 / 20

7
H: Mechanical brake
F: CHARGING SOCKET
The charging socket is used to charge the
batteries of the heavy duty trolley. Please,
follow the charging instructions page 12.
G: DISENGAGEMENT
If you need to push the heavy duty trolley
manually, the motor can be disengaged
using the handle on the motor located at
the rear of the trolley (G).
For disengagement, turn the handle dow-
nward. Always switch off the heavy duty
trolley and use the mechanical brake befo-
re you engage or disengage.
To deactivate the disengagement, pull the
disengagement handle up until you feel a
click. It is only possible to drive the hea-
vy duty trolley via the tiller head and the
motor, when the disengagement is deacti-
vated. If you try to switch on the heavy duty
trolley with the disengagement activated,
the status light (A) flashes. To reset this
error, turn off the heavy duty trolley and
deactivate the disengagement. Turn the
trolley on again and it is ready for use.
REMEMBER: Always deactivate the disen-
gagement after use if it has been activated.
WARNING! When you disengage, the brake
will be disengaged and you should take
care that the heavy duty trolley does not roll
away from you. Always use the mechanical
brake of the heavy duty trolley, when disen-
gaged.
H: MECHANICAL BRAKE
On the front wheel of the heavy duty trolley,
there is a mechanical braking function. Tilt
the handle bar to the vertical position to
activate the mechanical brake.
F G
The mechanical brake activated
The mechanical brake deactivated
H
H
Tilt the wheel down approximately to ho-
rizontally to deactivate the mechanical
brake. The heavy duty trolley may only be
manoeuvred when the handle bar is tilted
down and the mechanical brake is thus
deactivated.
WARNING! Do not leave the trolley without
the mechanical brake activated.