Raven SmarTrax John Deere 50, Installation Manual

Page: 16 / 28

Chapter 3
12 John Deere 50/60/70 Series Combines - Steering Ready SmarTrax™ Installation Manual
•
Securely fasten the node using bolts or screws through at least two of the three mounting holes. When
mounted properly, the node should not become loose or rotate.
Install the Foot Switch
FIGURE 7.
Foot Switch Installed
1.
Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
2.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
3.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
4.
Locate the ENABLE connector on the node harness (P/N 115-4001-161) and connect it to the foot switch
cable connector.
Install the Road Switch
The ideal road switch installation location is in an open switch port in the machine’s console. If an open switch
port it not available, identify an alternate mounting location which is easily accessible to the operator.
Open Switch Port Installation
1.
Locate an unused switch port on the armrest console.
2.
Use a flat-head screwdriver to gently remove the cover of the unused switch port.
3.
Route the ROAD SWITCH connector of the node harness (P/N 115-4001-161) into the machine’s console
and through the open port.