Manual # 016-1001-061
3
C
H A P T E R
2
I
NSTALLATION
Use the following procedure to properly install the Smartboom system.
1.
Locate the 31 pin armrest bulkhead connector beneath the
armrest.
2.
Locate the connector that matches the Smartboom harness.
NOTE: Only 1 of the bulkhead connectors will plug into the
Smartboom harness. The bulkhead connectors are sexed
differently so you will not be able to tee into the wrong connector.
3.
The master switch is already connected internally to the
Smartboom harness.
4.
Connect the power leads to a good source of switched power.
5.
Installation is now complete.
6.
Refer to the Smartboom Operators manual for console setup
instructions.