Installation: Connect the Harness
11
INSTALLATION
FIGURE 4. OEM X3058 Connector Location
NOTE:
If installed on the machine, the AGCO Connect module will be connected to this plug.
3. Disconnect any existing components from the plug and connect the Fendt 200 gen3 V-Bus cable (P/N 115-
4010-241) to the X3058 connector.
4. Connect the remaining Deutsch connector to the AGCO Connect Module if installed in your tractor.
5. Locate the X4250 connector on the back of the roof.
FIGURE 5. OEM X4250 Connector
6. Disassemble X4250 connector by pushing the yellow tabs out and down.
7. Remove the connector from the pass-through and remove the yellow wedge on top.
8. Insert the pins from the Fendt 200 gen3 V-Bus cable (P/N 115-4010-241) into slot 5 and 6 of the X4250
connector (pin 5- yellow, pin 6- green). Reference the image below.
step 6
step 7
