Chapter 1
2
OmniSeed™ Viper Pro™ Installation & Operation Manual
Hydraulic Safety
•
Raven Industries recommends that appropriate protective equipment be worn at all times when working on
any hydraulic system.
•
Never attempt to open or work on a hydraulic system with the equipment running. Care should always be
taken when opening a system that has been previously pressurized.
•
When disconnecting the hydraulic hoses or purging is required, be aware that the hydraulic fluid may be
extremely hot and under high pressure. Caution must be exercised.
•
Any work performed on a hydraulic system must be done in accordance with the machine manufacturer’s
approved maintenance instructions.
•
When installing hydraulics or performing diagnostics, maintenance or routine service, ensure that
precautions are taken to prevent any foreign material or contaminants from being introduced into the
machine’s hydraulic system. Objects or materials that are able to bypass the machine’s hydraulic filtration
system will reduce performance and possibly damage the hydraulic valves.
Electrical Safety
•
Always verify that the power leads are connected to the correct polarity as marked. Reversing the power
leads could cause severe damage to the equipment.
•
Ensure that the power cable is the last cable to be connected.
•
Disconnect the Viper Pro field computer before jump-starting the vehicle.
•
Disconnect the Viper Pro field computer and any other Raven systems before welding any component of
the machine.
CAUTION
Summary of Contents for OmniSeed Viper Pro
