Raven OmniSeed Viper Pro, Calibration & Operation Manual

Page: 128 / 308

Chapter 5
116 OmniSeed™ Viper Pro™ Installation & Operation Manual
Setting or Resetting Distance and Individual Nodes
To reset an individual node, or the Viper Pro odometer from the main screen:
1.
Touch the Product Control area at the bottom of the main screen.
2.
Touch the Tally Registers button at the bottom of the CAN Controller Status screen.
3.
Touch the Next button on the Tally Registers screen to display the Viper Pro Odometer screen.
4.
Using the on-screen keyboard, enter the desired distance values in the appropriate fields. Touch the Set
button to save the entered values. To reset the Odometer, touch the Reset button. The Viper Pro odometer
is reset to zero.
5.
Touch Next . The Node 1 screen displays.
6.
To set tally data for any of the displayed totals:
a.
Touch the desired field to modify.
b.
Enter the desired value and touch the Set button next to the entered value.
7.
To reset the data in the fields, touch the Reset button to the right of the value to reset.
8.
Repeat step 6 or step 7 for each node.
9.
Touch OK . Viper Pro saves the changes.
Note:
Field volume, field area, and tank volume can be reset while in a job. Total volume and total area
can only be reset while a job is not in progress.