Raven OmniSeed Viper Pro, Calibration & Operation Manual

Page: 121 / 308

5
Manual No. 016-3001-015 Rev. C 109
Using the OmniSeed Viper Pro System
Scout Tab
The Scout tab allows the vehicle operator to create a map of field features or locate areas of interest during an
active job. The scout map features may be recorded during a field operation or a scout map may be created
prior to an operation, stored on the Viper Pro and then reloaded for a new job.
Note:
GPS drift may cause issues with pre-recorded scout maps. Prior to beginning any applications
using a previously recorded scout map, check that the scout map location is accurate enough for
the field operation(s) being performed.
Contact a local Raven dealer for more information about available GPS correction sources and
services which may help avoid issues with GPS drift and scout maps.
Field features may include, but are not limited to:
•
Field boundaries
•
Weed or insect infestations
•
Tile lines or waterways
•
Rocks
•
Trees
•
Section Control apply/no-apply zones
Access the Scout tab to record a zone, path or point to mark a field feature during an active job. Refer to the
Scout Tab section on page 109 to customize the scout map display on the Viper Pro. Refer to the Marking a
Field Feature section on page 110 for details on the available features and zones.