PAGE 31/36 |
Installation manual
|
016-8000-028EN
|
Rev. B
CRX/ ROS INSTALLATION | CRX/VIPER 4+ ROS - RS1 | RAVEN EUROPE GENERIC
3
RS1 INSTALLATION
The RS1 mounting package comes with 2 metal strips
with an adhesive: 107-0172-618. Insert the included
screws into the metal strips and screw the fixed mount:
107-0182-531 onto the metal strips (Figure 38). Tape
the metal brackets as close to center of the roof as
possible. Make sure the roof is clean and dry before
mounting the strips. This mount stays permenant on
the tractor.
On the bottom of the RS1 there are 4 screws located,
unscrew them and insert the SIM into the SIM slot. The
SIM must be inserted into the J11 slot or the RS1 will
not receive any signal (Figure 39).
Mount the Latch Plate: 116-0159-802 onto the RS1
using the provided screws (Figure 41). This latch plate
stays connected to RS1.
Connect the RS1 with latch plate to the fixed plate and
secure it with the latch. Connect the connecter.
The LAIRD antenna is the main receiver of the RS1. The
RS1 / LAIRD-antennas should be mounted atleast 50
cm apart (Figure 47).
Furthermore, the following guidelines must be
observed when installing the GPS antenna:
•
Mount the GPS-antenna with the connectors
pointing to the backside.
•
Mount the GPS-antenna in front of the rear
axle.
FIGURE 38 BOTTOM ASSEMBLY OF RS1 MOUNT
FIGURE 39 INSERT SIM CARD INTO THE J11 SLOT
FIGURE 40 MOUTING THE RS1 ON THE GENERIC
BRACKET
