PAGE 26/36 |
Installation manual
|
016-8000-028EN
|
Rev. B
Raven Industries Inc.
CRX/ ROS INSTALLATION | CRX/VIPER 4+ ROS - RS1 | RAVEN EUROPE GENERIC
1.2.12
HEAVY-DUTY CARRARO FRONT AXLE WITH
INDEPENDENT SUSPENSION
Tractors with independent suspension (e.g. Carraro
front axle) a special wheel angle sensor bracket must
be fitted (Figure 30). This assembly requires a wheel
angle sensor with a much wider range (180°) in
connection with the larger wheel turn (blue coloured
wheel angle sensor). The wheel angle sensor should be
mounted at the right side behind the front axle of the
tractor (Figure 30).
Required parts:
•
180° wheel angle sensor
•
Wheel angle sensor bracket
•
M8 threaded stub with nuts
•
2x M8 ball joint
•
Carraro front axle wheel angle sensor bracket
•
Carraro front axle tie rod bracket
Method of mounting:
•
Install the wheel angle sensor to the bracket.
•
Mount the bracket to the front axle.
•
Set the arm of the sensor approximately 20
degrees off center (
). This means that
the ball and socket joint of the wheel angle
sensor are flush with the ball joint of the
control rod. This in order to prevent, when fully
to the left, the arm of the sensor and the
threaded rod with the ball joints scissors with
each other.
•
Cut the threaded rod to measure. The ball
joints are center to center 180mm long. Fit the
clamp to the tie rod and the threaded rod with
ball joints.
•
After mounting check the mechanism by
steering fully left and right.
FIGURE 30 CARRARO FRONT AXLE
FIGURE 31 SENSOR WITH BRACKETS
