CHAPTER 4
52
Boom Recirculation Installation and Operation Manual for Case IH 50 Series Patriot Sprayers
ADJUST RECIRCULATION TIMES
To adjust the time allowed for recirculating each section:
1. Open the UT Menu and select the RCM-Sprayer Menu button.
2. Select the Tools Menu softkey along the right side of the display.
3. Select the Equipment Setup tab along the top of the display.
4. Use the next button to access the Section Auto-Operation Times page.
5. This page allows the operator to adjust the section recirculation times for the specific application system or
current chemical suspension.
OPERATION
REQUIRED CONDITIONS FOR RECIRCULATION
The following conditions are required to initiate the boom recirculation feature:
• Confirm that the Boom Recirculation feature is enabled. Review
Enable Main Product Recirculation
• Ensure the tank fill feature is not enabled.
• Toggle the product pump on (switch/softkey).
• Ensure all boom sections are toggled on.
• Ensure the active spray width is zero.
• Recirculation hand valves between sections must be open.
NOTE:
Boom Recirculation is not supported in Bypass, High-Flow, or High-Flow VP control modes. The
crossover hand valves need to be manually closed when operating in one of those previously listed
control modes.
• Either enable the Auto Recirculate feature or manually initiate recirculation by selecting the Recirculation
softkey on the Home page.
UT Menu
RCM-Sprayer
Menu
Tools Menu
Boom
Recirculation
Confirm
Equipment
Setup
Summary of Contents for Case IH 50 Series
Page 60: ......
