![background image](http://html2.mh-extra.com/html/raven/600s/600s_installation-and-operation-manual_3827902012.webp)
Chapter 2
8
600S™ Installation and Operation Manual
Viper
®
4 Configuration
Once the 600S Antenna is installed, configure the system in the Viper 4 software to ensure proper
communication between the components.
Note:
Depending on the version of software being used, the screens may appear slightly different than
shown.
Software Configuration
1.
Select the node system configuration button from the Viper
®
4 Start-Up Screen.
2.
Select the serial device configuration button.
FIGURE 4.
Device Redetect
3.
Press the device redetect button. The Viper 4 will start detecting serial devices.
Note:
If the 600S is detected properly, the 600S will be listed on this page. If the 600S is not listed,
additional software may be required to allow the system to communicate or be configured.
FIGURE 5.
Detecting Serial Devices
4.
Configure the 600S on the GPS Configuration Screens based of the type of differential or accuracy.