Ravelli HR EVO 200 SMART, Use And Maintenance Manual

Page: 141 / 357

Use and maintenance manual HR EVO Smart
Pag.24
Rev.1 08/09/2021
EN
Installation
⚠
For appliance installation and use it is necessary to observe all of the local, national and European laws and regulations.
⚠
Appliance installation and the preparation of the building work must observe the regulation in force in the country of installation
(ITALY = UNI 10683).
📌
The installation activities must be carried out by a technician that is qualified and/or authorised by the Manufacturer. The staff
in charge of installation must issue a declaration of conformity of the system to the buyer, whereby they take full responsibility
for the final installation and good operation of the installed product.
📌
Ravelli shall not be held liable if these precautions are not followed.
Requirements for the installation premises
The appliance installation room must be sufficiently ventilated. To fulfil this requisite it is necessary to equip the room with an air intake
connected to the outdoors.
📌
The installation room must have an air intake with a free cross-section of at least 80 cm
2
or 100 cm
2
in case of boiler.
📌
For installation in the presence of other combustion appliances or VMC system it is necessary to check the appliance for
correct operation.
The appliance must be placed inside living quarters. It must never be installed outdoors. The volume of the room where it is installed
must be suitable for the power of the appliance and, in any case, greater than 15 m
3
.
⚠
When extraction fans (example: extraction hoods) are used in the same room or space as the appliance, this can cause
problems to appliance operation.
⚠
The appliance must be installed on a floor with suitable load capacity. If the existing position does not fulfil this requirement,
it is necessary to take due measures (for example, using a load distribution plate).
⚠
Provide due insulation if the surface is made of flammable material.
If the side walls adjacent to the appliance are made of a flammable material, it will be necessary to position the appliance at least 30
cm from them.
If the floor that the appliance is standing on is flammable, we recommend duly insulating it. Objects and parts that are heat-sensitive
or flammable cannot be stored near the appliance; in any case, keep such objects outside the area bounded by the minimum
distances indicated above.
Appliance installation must guarantee easy access to clean the appliance, the exhaust ducts and the chimney.