Set Up Instructions:
1. Setting Up The Tripod:
To set up the tripod, Grasp the legs of the tripod, then pull each leg away
from the center until it reaches the first lock position. Do this for each leg then ensure the tripod is
stable before releasing it completely on the ground.
2. Mounting The Pistol Grip Head:
To install the pistol grip head, first, position the head on the head
mounting plate located on top of the center column and thread it on in a clockwise rotation until the
head is tight.
3. The Quick Release Plate:
To first remove
the quick release plate from the head, loosen
the silver knob located on the top and side of
the pistol grip head. Next, press the safety
lock button in and slide the plate off. Next,
position the plate on the bottom of your
camera aligning the screw threads with the
camera mounting hole, then rotate the screw
clockwise to tighten. Align and slide the
quick release plate back on the head until it is
centered and you hear the safety button
click. Finally, tighten the silver knob to secure
to plate to the head.
4. Height Adjustment:
Adjusting the height of the tripod can be done by simply flipping the leg height
adjuster locks open, then pulling the legs downward until the desired height is obtained. flip the leg
locks back down to lock the legs into place. The leg height adjuster flaps are also equipped with Allen
screw heads to fine tune the tension used to lock the leg in place. You can also utilize the gearless
elevated center column to raise the height of tripod further by loosening the center column lock knob,
then pulling the head upwards until the desired height is achieved. Lock the column into place with the
elevator lock knob to prevent the head from retracting back down.
5. Adjusting The Tilt:
To adjust the tilt or rotation angle of the head, Squeeze the pistol grip lever to
release tension on the ball, Now the head will rotate freely to the desired position.
6. Using The Feet:
The rubber feet on the tripod can be removed or
retracted to reveal the turf spikes that are ideal for carpet, grass or any
area that has a soft surface. To remove the rubber feet, firmly hold the
tripod with one hand and with the other, grasp one of the feet, then
pull down and outward. To retract the rubber feet, simply turn the feet
in a clockwise rotation until it reaches the top of the threads.
Summary of Contents for APGL4
Page 1: ...APGL4 Model Tripod...
Page 5: ......
