9
NOTE
: Removal of the Corner Screw Stakes will not decrease
stability of the ice surface.
RESURFACING
Adding more water to the surface of your RAVE EZ Set Ice Rink
and allowing it to freeze will refresh the ice surface smoothly.
It is recommended that you avoid resurfacing your ice until
late in the afternoon or at night after you are done skating for
the day. When resurfacing you should evenly spread a shallow
layer of water across the entire rink area to maintain a level,
smooth skating surface. Consistently resurfacing your ice will
give you a harder top layer of ice that will be less prone to
cracking.
To remove minor cracks in the ice: Scrape enough ice shavings
with your skate or grab snow if available and pack it in the
crack tightly and wet it down. Use a puck, smooth over the ice
surface until smooth and level with the rest of the ice surface.
REMOVING YOUR ICE RINK
Allow ice to thaw completely with spring thaws. Tip down the
side of the liner in the lowest point of the ground slope and let
the water run off the liner.
1.
Completely dry all parts of the unit.
2.
Clean and store following instruction on page 11.
