23
9. PARAMETER SETTINGS
ATTENTION: Before entering the setup mode make sure that the battery
supply is sufficient. A low battery may cause the micro-processor to block. If
this happens remove the empty battery and replace it with a fully charged
battery. You should be able to start the indicator in the normal way.
To enter the setup mode, turn on the indicator and keep the
key pressed for 20
seconds. You will go through the normal start-up routine (all segments on; software
version; calibration number and weight) and end up in the “P_01” with the right digit
flashing.
At this stage you may proceed as follows:
To enter parameter 01 press the
key quickly.
o
The display will show the setting for this parameter at this moment.
You may change the setting by using the
∧
or the
∨
key.
OR
You can accept the setting by pressing
.
OR
To move to the next parameter you press the
∧
key.
OR
To move to the previous parameter you press the
∨
key.
To leave the set-up mode you do the following:
With P_XX in the display press the
key quickly.
o
The display will show “P_00”
Press the
key again quickly.
o
If a change was made to the settings the display will show “SET__”
briefly and then return to the normal weighing mode. The calibration
number will be increased by every time a change was made in the set
up and also after a new calibration.
o
If no change was made, the display will return into the normal weighing
mode.
In the following pages the different parameters are explained and the standard
settings are given. Parameters that are not used yet will not be accessible or
displayed with underscores.
