Thermostatic ignition instructions
Attention: before using the space heater for the first time and after long periods of non-use, we recommend
switching on the control buttons several times alternately and without gas flow in order to facilitate its
operation.
Open the gas outlet by rotating the lever on the regulator to the correct position (Fig.2).
Turning on the space heater Regulate the adjustable thermostat by moving the thermostat button in opposite
direction of the clockwise to the position maximum. Press the gas valve button for 15 sec. and then press 2 or
3 times the spark ignition button .
If the flame from the main burner is not burning repeat again the process.
Keep the gas valve button pressed for about 20 seconds after the ignition so that the thermal element
reaches the desired temperature and the burner will not cut off. When the room reaches the desired
temperature, set the desired temperature level at the point where the thermostat is on the device sets the
chosen level button.
If any anomaly is observed or spare parts are required, contact our Technical Service.
To turn the heater off
1.
Press and turn the knob to the lighting position.
2.
Turn off the valve on the gas cylinder.
PL EAS E N OT E!
Do not move and do not cover the heater after it is switched off until it cools.
CYLINDER REPLACEMENT
PL EAS E N OT E!
•
The cylinder must be replaced in a room with no fire.
•
Please ensure the gas control system is in OFF position.
1.
After the heater has been turned off and cooled down, take the cylinder from the housing (first check the
cylinder valve is turned off!).
2.
Disconnect the pressure-reducing valve from the cylinder in accordance with the manual attached
to the pressure-reducing valve.
3.
Replace the cylinder.
4.
Connect the new cylinder, checking if no gas connections were loosened or damaged.
5.
Before connecting the pressure-reducing valve to the cylinder check if the gasket is present and
if it is in good condition.
6.
Leak test the system using e.g. soapy water.
STORAGE
1.
Always close the gas cylinder valve after use or in the case of any troubles.
2.
If the heater is not to be used for a long time, disconnect the cylinder. Disconnect also the pressure-
reducing valve and hose.
3.
The cylinder must be stored outside the room, in a well-ventilated place out of reach of children.
4.
The disconnected cylinder must possess protections on the threaded connections and valve
and cannot be stored in the garage or another confined space.
5.
The heater can be stored at home solely after the cylinder has been disconnected and removed from
the heater.
6.
Check the gas valve for its tightness and possible damage. If the user suspects any damage, she should
have the gas provider replace it.
7.
Do not store the LPG cylinder in below-grade rooms, in multi-floor buildings and houses or in places
without the sufficient ventilation.
CLEANING AND MAINTENANCE
PL EAS E N OT E!
•
Do not carry out maintenance works after switching the heater off and before it cools down.
•
Ensure the gas supply has been disconnected and the gas control knob is in the OFF position.
•
Do not expose the starter, controllers and parts under the burner to water. Do not use
the heater if any of those parts was exposed to water until the device has been inspected
or repaired by the service technician.
