10
✓
Open the door to let the ice melt. To speed up the defrosting process, you can place a bowl with hot
water on the shelf and close the door of the fridge and freezer.
Do not use metal tools or electric heaters to accelerate the defrosting process.
✓
Remove water from the fridge and freezer with a soft cloth. Clean the device inside and outside using
a soft, wet cloth with a neutral washing agent. Dry the chambers.
Do not pour water over the outer part of the refrigerator. This can damage the insulation layer.
It is forbidden to wash with hot water, acid, alkalis, gasoline, benzene, caustic means, alcohol or
abrasives.
✓
Place food in the fridge and freezer, set the thermostat to the desired position and plug the device.
To ensure hygiene, clean the fridge interior with sufficient frequency. To do this:
✓
unplug the power cord from the electrical outlet
✓
wash with a soft damp cloth with a neutral detergent
✓
dry afterwards.
Pay special attention to keep the rubber seals at the door in the appropriate condition. They should always be
clean.
If the device is not used for an extended period of time, remove clothes, clean the fridge and freezer chamber
and dry them. The door should remain open.
REPLACING THE BULB
Before replacing the light bulb set the thermostat knob to the “0” position and disconnect the refrigerator from
the
power
supply.
Remove
the
food
from
the
top
shelf
and
pull
shelf
forward.
A bulb is located at the rear of the thermostat housing. To remove light bulb cover, unbend its rear part slightly
and slide the cover forwards, as shown in the figure. Twist off a burnt bulb, twist in a new one and replace the
bulb cover. Light bulb parameters: Max 10W; Bulb thread: E 14
TROUBLESHOOTING
Laudable sound of running water is normal for working compressor.
Laudable tapping is a reaction to sudden changes of temperature.
Hot compressor
–
during operation, the compressor’s temperature can reach 90°C
