GB
Page 13 of 32
INSTRUCTION, USE AND
MAINTENANCE MANUAL
G1150.30MAGIC - G1150.30MAGICIT
RAVAGLIOLI S.p.A.
7107-M001-0_R
Fig. 12
The base can be moved as for the column (
Fig. 11 pos.
A
) by unscrewing the fixing screws of the base (
Fig. 11
pos. B
) to the column and by sliding the base itself into
the proper slots until the required measure.
1. To remove the lateral guard (
Fig. 12 pos. 1-2
) of the
machine.
2. To unscrew the screws (
Fig. 12 pos. 3
) and the nuts
near the central slots (
Fig. 12 pos. 4
) playing atten-
tion to not remove the nuts from the proper screws.
3. To remove six remained screws (
Fig. 12 pos. 5
).
4. To move the base (
Fig. 12 pos. 6
) into the required
position (to 43” or 45”) and if necessary to use a lift-
ing device (
Fig. 12 pos. 7
).
5. To lock the base three screws (
Fig. 12 pos. 3
) with a
couple of 80 Nm.
6. To place six screws (
Fig. 12 pos. 5
) previously re-
moved and to lock them on the base side with a cou-
ple of 80 Nm.
7. To assembly again the lateral guard (
Fig. 12 pos. 1-2
)
of the machine.
NOTE:
after the assembly, to check the right position of
the tools. Lock the rim on the chuck center. With
the bead breaker arm, check that the distance
between the roll and the rim edges (upper and
lower) is the same. Repeat all the procedures
starting from point one if the distance is not the
same.
MAKE SURE THAT THE TYRE
CHANGING MACHINE COLUMN IS
STABLE: USE A CABLE HELD BY A
HOIST AND HOOK THE CABLE TO
THE COLUMN ITSELF
(
FIG. 12 POS.
7
)
.
10.5 Controls
BEFORE STARTING UP THE TYRE-
CHANGER, BE SURE TO BECOME
FAMILIAR WITH THE LOCATION
AND OPERATION OF ALL CON-
TROLS AND CHECK THEIR PROPER
OPERATION (SEE PAR. CONTROLS).
