Instructions for Use MPR1 DATALOGGER
Manufacturer:
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany
Page 30 of 98
If the memory is more than 50 % full, the user now receives the recommendation to delete (clear) the
memory. This recommendation can be ignored, which however has the consequence that the condition
"Memory full" will more than likely be reached instead.
Software version
If the memory is to be deleted now, proceed according to 4.2.2
Software version
Deleting the memory can take a short while.
4.2.1 General notes on the key functions
Please observe: The functions of the keys in the left-hand row cannot be changed, and for this
reason the symbol has been printed on the respective operating surface. The keys in the right-
hand row are soft keys with variable functions. The function is defined by a symbol on the display
of the respective key. Please observe the other key function, if the Shift key is pressed in
addition.
4.2.2 Deleting the memory
Please observe: The memory mode set has a decisive influence on the potential recording
duration. Only a fraction of the memory which is required for the recording of the curves and
trends in short-play mode is required for the mere trend recording in long-play mode. However,
in this case only trends will be displayed off-line on the laptop.
Check the memory symbol
(right-hand top in the display) to ensure that sufficient free
memory is available prior to recording. A black bar indicates a free memory. If insufficient free
memory is encountered during the recording process, a warning is released indicating that the
eldest memory data will be overwritten when continued.
Depending on the memory display you can now decide whether all previously saved patient data are to be
erased or not. You should decide in favour of erasing if you want to ensure a maximum of recording time.
For irretrievable erasure of the data saved, press the Del delete key.
This
document
is
for
information
only
