Rauch QUANTRON-K2, Instruction Manual

Page: 41 / 102

Operation QUANTRON-K2
35
4
4.5.5 Calibration
In this menu, the flow factor is determined based on a calibration test and saved
in the control unit.
Perform the calibration:

Before spreading for the first time.

If the spreading material quality has changed significantly (moisture, high
dust content, cracked grain).

If a new type of spreading material is used.
Perform the calibration test with a running agitator and stationary machine or
while driving a test track.

Place a collection container (tray, foil, etc.) on the ground under the
Single-disc spreader.
Entering the working speed:
1.
Call up the Spreading mat. settings > Calibration menu.
2. Enter the average working speed.
This value is required to calculate the metering slide position during the
calibration.
3. Press the Enter key .
 The new value is saved in the control unit.
 The Calibration test operating screen is shown on the display.
Running the calibration:
4. Press Start/Stop (also press the Enter key for HydroControl).
 The metering slide opens and calibration is started.
 HydroControl option: Agitator and spreading disc are started.
n
WARNING
Risk of injury when performing the calibration
Rotating machine components, the moving spreading width limiter
and ejected spreading material can cause injuries.
 Ensure that all preconditions are been met. before starting,
when interrupting and when finishing calibration.
 Observe the Calibration chapter in the operating manual of
the Single-disc spreader.
NOTICE
HydroControl option: After pressing the Start/Stop key, an alarm window
appears.

Press the Enter key to activate the disc start.