Rauch AXIS-M 20.2 EMC, Instruction Manual

Page: 111 / 236

Commissioning
91
A
AXIS
AXIS
20.1
A
X
IS
20.
2
A Commissioning
A.1 Mounting the universal drive shaft with shear pin protection to AXIS 20.2
The machine AXIS 20.2 M EMC is equipped ex works and delivered with a drive
shaft with shear pin protection.
This section is not relevant for the machine version.

See 8.3: Mounting the universal drive shaft at the machine, page 50 .
A.1.1 Mounting the universal drive shaft
1. Check the installation position.

The drive shaft end that is marked with a tractor symbol must point to the
tractor.
n
CAUTION
Material damages due to unsuitable drive shaft
The machine is delivered with a drive shaft that is designed according
to the device and performance.
The use of incorrectly dimensioned or inadmissible drive shafts, for
instance without guard or suspension chain, may cause personal
injury or lead to damage to the tractor and/or the machine.

Use universal drive shafts approved by the manufacturer only.
 Follow the directions in the operator’s manual of the universal
drive shaft manufacturer.
NOTICE
If you want to mount a universal drive shaft with ratchet clutch, please proceed
as described in chapter
8.3: Mounting the universal drive shaft at the machine,
page 50 .
2. Remove the protective cap.
3. Loosen the locking screw [1]
of the universal drive shaft
guard.
4. Turn the universal drive
shaft guard to the demount-
ing position.
5. Pull the universal drive shaft
out.
Figure 1: Loosen the universal drive shaft
guard
1
AXIS 20.2
K
D
R
C
Q
W
EMC