Rauch AXENT Series, Operator'S Manual

Page: 142 / 170

General maintenance and servicing 9
136
9.8 Setting the conveyor belt
9.8.1 Adjusting the position of the conveyor belt
For the correct distribution of the spreading material in the spreading unit hopper,
the conveyor belt must be centred on the drive rollers.
1. Measure the distance between the conveyor belt and the hopper wall on
both sides.
Figure 9.15: Inspection of the conveyor belt position
[1] Conveyor belt
[2] Hopper wall
[X] Measure the distance between conveyor belt and hopper wall on left/right
Adjust the drive roller if the deviation between the two sides is greater than
20 mm .
The bearings of the drive roller are located at the rear on each side of the
spreader coupling points in the direction of travel
2. On the side with the larger
distance, undo the nuts [1] of
the drive roller by about two
turns.
3. Loosen the adjustment
screw with nuts [3] until the
distance on each side is the
same.
4. Re-tighten the nuts [1] and [3].
Figure 9.16: Position of the drive roller
2
1
1
1
2 3