28
CUTOUT
GROOVE
Wear gloves and eye protection during disassembly, and take care not
to allow the return spring to come out.
Installation Instruction
①
Pass the recoil starter rope through the rope in the recoil
starter pulley and make a figure-eight knot at the rope end.
Check the rope foe wearing and broken before reassembling, then,
install it.
②
Hang the side hook of the recoil starter spring in the
groove of the recoil starter case, set the recoil starter
spring into the case with counterclockwise rotating
starter spring.
③
Set the recoil starter spring outside hook into the groove
of the recoil starter pulley.
④
Set the starter drive cam on the recoil starter pulley, and
install the return spring on the recoil starter pulley while
hooking it on the side of the driving cam.
⑤
Install the spring, drive guide and fixing screw in order and
tighten to the specified torque.
Screw torque value
:
10±2 N·M
REEL COVER GROOVE