Rational Combi-Duo Gas, Original Installation Manual

Page: 12 / 80

4 | Preparations en
12 / 80 80.51.374_iCombi Pro-iCombi Classic_CD G_IM_V02_Eur-west
Bottom unit:
Gas unit Top unit Article num-
ber
6-1/1 Gas
right-sided
hinge 6-2/3 or
6-1/1 Elec-
tric/Gas 60.75.751
6-2/1 Gas
right-sided
hinge 6-2/3 or
6-1/1 /
6-2/1 Elec-
tric/Gas 60.75.752
6-1/1 Gas
left-sided
hinge 6-2/3 or
6-1/1 Elec-
tric/Gas 60.75.753
6-2/1 Gas
left-sided
hinge 6-2/1 Gas
left-sided
hinge 60.75.754
You can find further information on other
Combi-Duo variants, such as with gas
units as the bottom unit, in the associated
installation manuals.
Scope of delivery [ Photo 01 ]
1 Base plate top 2 Base plate below
3 Feet at front 4 Feet at the rear
5 Exhaust gas stack 6 Heat protection
cover
7 Shaft cover 8 Exhaust pipe
9 Ethernet cable
Dimensions
Note that with a Combi-Duo system, the
connection heights and access heights
change for both units. You can find draw-
ings of the setup and precise dimensions
and height of the top rack rail for the dif-
ferent configurations in separate dimen-
sion drawings.
NOTICE! If the rack height is over 1600
mm [63 inches], affix the safety label to
the unit.
Key for dimension drawings:
1 Height of top
rack 2 Top unit access
height
3 Bottom unit ac-
cess height 4 Height of top
unit water drain
5 Height of bottom
unit water drain
4 Preparations
Position the bottom unit
In order to position the bottom unit for the
Combi-Duo setup, mount the unit onto a
stand with feet, castors or a levelling kit.
Note that the wall clearance of the Combi-
Duo unit is at least 50 mm [1.97 inches].
Note the description in the unit's installa-
tion manual for positioning the unit on the
stand.
Align the bottom unit
n
Align the stand: Position the unit and
check the alignment with a spirit level
in the cooking cabinet. If necessary,
align the castors or feet evenly so that
the unit is standing securely.
n
Align the levelling kit: Align the level-
ling kit and check the alignment with a
spirit level before positioning the
lower unit on the levelling kit.
5 Installation
Setting up the Combi-Duo and the top
unit
NOTICE
Mounting and attachment of the top
unit on the top base plate
The top unit is attached to the top base
plate with only three screws. The fourth
attachment is difficult to access through
the cover for flue pipes and is not
absolutely necessary.