49
E2
4. SPINDLE LOCK BUTTON
Clean the grinder spindle and all parts to be
mounted. For clamping and loosening the
grinding tools, lock the grinder spindle with the
spindle lock button.
Warning: Actuate the spindle lock
button only when the grinder spindle is
at a standstill!
5. HAND GRIP AREAS (SEE FIG. F)
Always hold your angle grinder firmly with both
hands when operating.
F
6. SLIDE ON/OFF SWITCH (SEE FIG. G)
To start the power tool, first press the back of on/
off switch, then push the on/off switch forward.
To lock the on/off switch, press the on/off switch
down at the front until it engages.
To switch off the power tool
，
briefly press down
the back of the on/off switch and then release it.
NOTE: The machine is equipped with the
function of Accidental Start Protection.
The machine will not run when you put the
battery on the machine if switch is engaged
“on” position to make sure safety to user.
The machine will work only after you
switching off and switching on again.
G
7. REMOVING THE GUARD
Never remove your guard for any other
working conditions.
To remove, first take
off the disc and both flanges. Then open the
clamping lever and rotate the guard to align the
projections with the gear case cut outs, then
remove the guard. To re-fit the guard, repeat
this process in reverse. Keep all parts in a safe
place.
8. TO USE THE GRINDER (SEE FIG. H)
Attention: Do not switch the grinder on while
the disc is in contact with the workpiece.
Allow the disc to reach full speed before
starting grinding.
Hold your angle grinder with one hand on the
main handle and other hand firmly around the
auxiliary handle.
Always position the guard so that as much of the
exposed disc as possible is pointing away from
you.
Be prepared for a stream of sparks when the
disc touches the metal.
For best tool control, material removal
and minimum overloading, keep an angle
between the disc and the workpiece surface at
approximately 15
0
to 30
0
when grinding.
Use cautiously when working into corners as
contacting with the intersecting surface may
cause the grinder to jump or twist.
When grinding is complete, allow the workpiece
to cool. Do not touch the hot surface.
H
15
0
-30
0
E3
15
0
-30
0
