34
OPERATING
INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for driving in and
loosening screws.
BEFORE PUTTING INTO OPERATION
1. CHARGING THE BATTERY(SEE FIG. A)
NOTE:
a) Do not use any charger other than that
specifically provided for use with the
equipment.
b) If the battery pack is very hot you must
remove your battery pack from the charger
and allow time for the battery to cool down
before recharging.
c) The battery in your new tool is not charged
when it leaves the plant. Therefore it must be
full charged before using the first time.
d) Please charge the battery to reach full or no
less than half charge before storage. If the
tool will not be used for long periods of time,
charge the battery every 3-6 months.
Plug the charger plug into a suitable power
outlet. Next, connect the DC plug to the Charging
Socket(7). When charging is completed, unplug
the charging, disconnect the Charger from the
screwdriver. The screwdriver is ready to be used
Important: When charging, the charger
and screwdriver may become warm to the
touch, this is normal and does not indicate a
problem.
Warning: When battery charge runs out
after continuous use or exposure to
direct sunlight or heat, allow time for the tool
to cool down before re-charging to achieve
the full charge.
CHARGING INDICATOR
Light
Status
on
Charging
off
Fully Charged
OPERATION
1.FITTING AND REMOVING BITS (SEE FIG. B)
To use any one of the short bits, insert the bit into
the bit holder and push the holder into the chuck
as far as possible. To remove the bit, simply pull
it out of the bit holder.
NOTE:
Always use a bit holder when fitting the
short bits!
B
2. FORWARD / REVERSE SWITCH (SEE FIG.
C1,C2)
For screw driving use forward rotation marked
“◄◄” (lever is moved to the left). Only use
reverse rotation marked “►►” (lever is moved to
the right) to remove screws or release a jammed
drill bit.
WARNING: Never change the direction
of rotation when the chuck is rotating,
wait until it has stopped!
C1
A