43
2. ON / OFF SWITCH (SEE FIG. C))
Depress the On/Off switch to start and release it
to stop your drill.
The on/off switch is fitted with a brake function
which stops your chuck immediately when you
quickly release the switch.
It is also a variable speed switch that delivers
higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of
switch trigger depression.
WARNING: Do not operate for long
periods at low speed because excess
heat will be produced internally.
3. SWITCH LOCK (SEE FIG. D)
The switch trigger can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
switch trigger, place the rotation control in the
center position.
4. REVERSIBLE (SEE FIG. E1, E2)
For drilling and screw driving use forward rotation
marked “
” (lever is moved to the left). Only
use reverse rotation marked “
” (lever is
moved to the right) to remove screws or release
a jammed drill bit.
WARNING:Never change the direction of
rotation when the chuck is rotating, wait
until it has stopped!
5. TWO-SPEED GEAR CONTROL (SEE FIG. F)
The drill has a two-speed gear control designed
for drilling or driving at LO (mark is 1) or HI (mark
is 2) speeds. A slide switch is located on top of
the drill to select either LO or HI speed. When
using the drill in the LO speed range, the speed
will decrease and the drill will have greater power
and torque. When using the drill in the HI speed
range, the speed will increase and the drill will
have less power and torque.
GEAR I
Low speed range: for screwdriving or working
with large drilling diameter
GEAR II
High speed range: for working with small drilling
diameter
WARNING:
To prevent gear damage,
always allow the chuck to come to a
complete stop before changing the direction
of rotation or the two-speed gear control.
D
E1
E2
B2
C