Page 3
Mounting
624POOLVOIP, 624MPOOLVOIP, 970VOIP
984RIP, 984RIPC1
Items Needed:
• POE port on Network Switch
• Drill
• Drill bit or knockout set
• Mounting screws
• Conduit with water tight connector
• 1/8” Allen wrench (provided)
• Screwdriver
• Mounting feet (provided)
Installation:
1.
After opening door on unit, use the Allen wrench to remove the 4 screws securing the internal plate.
2.
Completely remove the internal plate.
3.
Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the water tight
connector.
Note:
Be sure the hole sits far enough back so it doesn’t interfere with the internal plate when it’s reinstalled.
4.
Turn enclosure over and screw 1 mounting foot onto each mounting hole on the back of the enclosure using
provided screws.
5.
Using appropriate mounting screws, screw enclosure to the wall using the other side of the mounting feet.
6.
Run the Ethernet connection from the POE port on the Network Switch into conduit, bring the cable into the
enclosure through the water tight connector, and tighten conduit to connector.
7.
Connect the Ethernet cable to “DATA POWER IN” on POE input of phone. See programming section for phone
programming.
Items Needed:
• POE port on Network Switch
• Drill
• Drill bit or knockout set
• Mounting screws
• #10 spanner bit (provided)
• Conduit with water tight connector
• Screwdriver
• Wire nuts
Installation:
1.
Using the spanner bit, remove the 4 screws holding the front cover in place and remove the cover.
2.
Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the water tight connector.
3.
Using appropriate mounting screws, screw the enclosure onto the wall.
4.
Run the Ethernet connection from the POE port on the Network Switch into conduit, bring the cable into the
enclosure through the water tight connector, and tighten conduit to connector.
5.
Connect the Ethernet cable to “DATA POWER IN” on POE input of phone. See programming section for phone
programming.
