Installation:
1. Using the spanner bit, remove the 4 screws holding the front cover in place and remove the cover.
2. Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the water tight connector.
3. Using appropriate mounting screws, screw enclosure onto the wall.
4. Run telephone line in conduit, bring line into the enclosure through the water tight connector, and tighten conduit
to connector.
5. Connect incoming line to RJ11 connector and plug into RJ11 jack on board. Or, obtain a biscuit jack, terminate
your incoming line to the biscuit jack and plug the included phone line to the RJ11 connector on the biscuit jack.
Note:
Do not cut RJ11 jack of supplied line cord and splice phone line onto it.
6. Phone is preset to dial 911. If required to call an alternate number not given to RATH® at time of purchase, please
follow programming instructions on page 6-7. If phone is calling 911, screw internal plate back into place. Unit
is ready for testing.
Items Needed:
• Live analog phone line
• Drill
• Metal capable drill bit or knockout set
• Biscuit jack (provided with 690SYPOOL & 690RDPOOL)
• Mounting screws
• Wall anchors
• Conduit with water tight connector
• 3/32” Allen wrench (provided)
• Screwdriver
Installation:
1. After opening door on unit, use the Allen wrench to remove the 4 screws securing the internal plate.
2. Completely remove the internal plate.
3. Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the for the watertight
connector.
Note:
Be sure the hole sits far enough back so it doesn’t interfere with the internal plate when it’s reinstalled.
4. Using appropriate mounting screws and anchors, screw enclosure to the wall.
5. Run telephone line in conduit, bring line into the enclosure through the water tight connector, and tighten conduit
to connector.
6.
690SYPOOL & 690RDPOOL:
Connect incoming line to the biscuit jack, then plug the line cord connected to circuit
board to the RJ11 jack on the biscuit jack.
7.
990SYPOOL & 990RDPOOL:
Connect incoming line to RJ11 connector and plug into RJ11 jack on board. Or,
obtain a biscuit jack, terminate your incoming line to the biscuit jack, and plug the included phone line to the RJ11
connector on the biscuit jack.
Note:
Do not cut RJ11 jack of supplied line cord and splice phone line onto it.
8. Phone is preset to dial 911. If required to call an alternate number not given to RATH® at time of purchase, please
follow programming instructions on page 6-7. If phone is calling 911, screw internal plate back into place. Unit
is ready for testing.
690RDPOOL, 990RDPOOL, 690SYPOOL (YELLOW), 990SYPOOL (YELLOW)
Page 4
