９
１０
１１
１１
８
4. Installation of windscreen
5.Battery and power installation
6.Installation of rear license plate
cover
7.Installation of left and right
rearview mirrors
8.Assembly completion
Male
connector
The configured windscreen
(accessory 8) is taken and the screw
hole (as shown in the figure 8) under
it is aligned with two screws of
vehicle head, and then configured
screw (accessory 4(M4x12PB)) is
applied for successive locking (as
shown in the figure 5).
The skewed slot behind the seat (as
shown in the figure 9) is set as left
and right turning. At that time, the
seat cover is taken to see the
configured battery (as shown in the
figure 6).
The configured connecting wire in the
battery slot is taken to connect two
pairs of male connector and female
connector (as shown in the figure 6).
The battery socket shall be noted that
the red wire corresponds with red wire
and the black wire corresponds with
black wire, without false connection,
otherwise, the short circuit may be
caused. After connecting the wire, the
seat can be installed back.
The designated button in the rear is
aligned (as shown in the figure 10) for
pressing. At the same time, the
configured rear license plate cover
(accessory 1) is taken and tightly
plugged upwards along the rear card
slot and then rear button is loosened
(as shown in the figure 10).
The left and right rearview mirrors
(accessory 7) are taken and the
rearview mirror handspike is aligned
with the designated position (as shown
in the figure 11) and tightly plugged
along the slot (as shown in the figure
8). (The installation method of left
rearview mirror is similar with that of
the right rearview mirror)
Notes: When the vehicle is
assembled or disassembled, note
installation order of accessories and
keep accessories in good condition.
Female
connector
