EN
13
If the blade is no more able to cut (even after repeating
the sharpening operation several times), it is necessary
to replace it. In order to carry out this operation, use
butterfly wrench “1” and drift “3” locking the blade
(shown in picture 10).
In order to replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Italian Legislative Decree 81/08;
2) Remove the safety back fixed protection “A” (see
picture 11), by unscrewing the two slotted
screws “C” by means of a screwdriver (not
supplied by the manufacturer) as shown in picture
12.
Remove the fibre opening device “B” (see picture
13) by unscrewing screw “D” as shown in picture
12.
3) Insert drift “3” (see picture 13) into hole “E” in
order to lock the blade (the hole in the blade must
correspond to the hole in the structure).
4) Use butterfly wrench “1” in order to unscrew nut
“F” (see picture 13) and remove blade “G” (see
picture 14).
5) Replace the worn blade with the new one “2”,
being careful to center the blade on the ring gear,
in the correct position, and remember to assemble
it with the side with the writing Rasor positioned
towards the external side of the battery scissors.
6) Assemble all the components again and carry out
some cutting and sharpening tests.
12
3
16. BLADE REPLACEMENT
1
2
3
10
13
B
A
11
E
1
F
G
14
C
D
