EN
11
16
A
B
15
1
2
3
17
E
F
H
1
G
18
D
C
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary to
replace it. To carry out this operation, use butterfly
wrench “1” and drift “3” locking the blade (shown in
picture 15).
To replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Italian Legislative Decree 81/08;
2) Remove the fixed rear safety guard “A” (see picture
16) by unscrewing the cross-slotted screws “C”
by means of a screwdriver (not supplied by the
manufacturer) as shown in picture 17.
Remove the movable front safety guard “B” (see
picture 16) by unscrewing pin “D” and by removing
washer “E” as shown in picture 17.
3) Insert drift “3” (see picture 15) into hole “F”, so
as to lock the blade (the hole on the blade must
correspond to the one on the structure).
4) Use butterfly wrench “1” to unscrew nut “G” and
remove blade “H” (see picture 18).
5) Replace the worn blade with the new one “2”,
being careful to center the blade on the shaft in
the correct position; we remind you to assemble
it so that the side with the writing Rasor can be
seen by the operator.
6) Assemble all the components again and carry out
the sharpening.
15. BLADE REPLACEMENT