EN
11
15. BLADE REPLACEMENT
1
14
3
2
If the blade is no more able to cut (even after repeating the
sharpening operation several times) it is necessary to replace
it. To carry out this operation, use wrench “1” and drift “3”
locking the blade (shown in picture 14).
To replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Legislative Decree 242 dated 19 March 1996 (use of
personal protection devices);
2)
Remove the fixed rear safety protection “A” (see
picture 15) by unscrewing the three cross screws “C”,
“D” and “E” by means of a screwdriver (not supplied
by the manufacturer) as shown in picture 16.
Remove the mobile front safety protection “B” (see
picture 15) by unscrewing pin “F” and removing the
two washers “G” as shown in picture 16.
3)
Insert drift “3” (see picture 14) into hole “H”, so as
to lock the blade (the hole on the blade must
correspond to the one on the structure).
4)
Use butterfly wrench “1” to unscrew nut “L” and
remove blade “M” (see picture 17).
5)
Replace the worn blade with the new one “2”, being
careful to center the blade on the shaft, in the correct
position, and remember to assemble it with the side
with the writing Rasor positioned towards the external
side of the bench cutter.
6)
Assemble all the components again and carry out
the sharpening.
15
B
A
16
E
G
H
M
1
L
17
F
C
D
