EN
11
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary to
replace it. To carry out this operation, use wrench “1”
and drift “3” locking the blade (shown in picture 15).
To replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Italian Legislative Decree 81/08;
2) Remove the mobile front safety protection “A” (see
picture 16) by unscrewing pin “C” and removing
the two washers “D” as shown in picture 17.
Remove the fixed rear safety protection “B” (see
picture 16) by unscrewing the two cross screws
“E” by means of the proper screwdriver (not
supplied by the manufacturer) as shown in picture
18.
3) Insert drift “3” into hole “F” (see picture 19), so
as to lock the blade (the hole on the blade must
correspond to the one on the motor support).
4) Use wrench “1” to unscrew nut “G” and remove
blade “H” (see picture 19).
5) Replace the worn blade with the new one “2”,
being careful to center the blade on the gear, in
the correct position, and remember to assemble it,
so that the Rasor writing can be seen by the
operator.
6) Assemble all the components again and carry out
the sharpening.
15. BLADE REPLACEMENT
1
15
16
B
A
18
H
1
G
19
3
2
F
C
D
17
E
3