EN
11
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary to
replace it. To carry out this operation, use butterfly
wrench “1” and drift “3” locking the blade (shown in
picture 10).
To replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Italian Legislative Decree 81/08;
2) Remove the fixed rear safety guard “A” (see picture
11) by unscrewing the cross-slotted screws “C”
by means of a screwdriver (not supplied by the
manufacturer) as shown in picture 12.
Remove the movable front safety guard “B” (see
picture 11) by unscrewing pin “D” and by removing
washer “E” as shown in picture 12.
3) Insert drift “3” into hole “F” (see picture 13), so
as to lock the blade (the hole on the blade must
correspond to the one on the structure).
4) Use butterfly wrench “1” to unscrew nut “G” and
remove blade “H” (see picture 13).
5) Replace the worn blade with the new one “2”,
being careful to center the blade on the shaft in
the correct position; we remind you to assemble
it so that the side with the writing Rasor can be
seen by the operator.
6) Assemble all the components again and carry out
the sharpening.
14. BLADE REPLACEMENT
2
1
10
3
11
A
B
E
F
H
1
G
13
D
C
3
12
Summary of Contents for GRT-MINI
Page 1: ...use manual GRT MINI THREE PHASE CUTTING UNIT...
Page 13: ......
