10
EN
12. BLADE SHARPENING
13. LUBRICATION
Every 3-4 consecutive working days, it is necessary to
lubricate the pair of gears. To carry out this operation,
remove protective plug “A” located on the cutting unit head
and fill it with lubricating grease Rasor.
Screw plug “A” again few turns.
Screw plug “A” some turns every 3-4 consecutive working
days (see picture 11).
Screw the plug completely and fill it again.
The blade must never be dirty with grease or oil.
11
WARNING
2
9
A
10
1
3
After many hours of a continuative use of the cutting unit, or
if it would not be able to cut anymore, it is necessary to sharp
the blade.
To carry out this operation, start the blade and press sharpener
“2” located on it for 3-4 seconds (by pressing push button
“1”, as shown in picture 9).
Repeat the operation 2-3 times.
If the sharpening operation is not effective, check the wear
of emery grinding wheel “3” (see picture 10).
If emery grinding wheel “3” is too worn or dirty, replace it.
Summary of Contents for FP100
Page 1: ...PNEUMATIC CUTTING UNIT use manual FP100 ...
Page 13: ......
