2
With the
PILOT THERMOCOUPLE ASSEMBLY
(Figure 2A) attached to the
PILOT SUPPORT BRACKET
(Figure 2B),
insert the
10-32 BOLTS
(Figure 2C) through the pre-drilled holes of the Pilot Support Bracket and into the threaded
holes of the Pilot Thermocouple Assembly (Figure 2A). Tighten with flathead screwdriver.
STEP TWO: ATTACH PILOT (Figures 2 thru 5)
NOTE:
The following pilot attachment instructions apply to each burner model shown in Figures 2 thru 5.
FIGURE 2 (F, FX, FA and FAX Burners)
B) Pilot Support
Bracket
E) 10-32 nut
C) 10-32 bolts
F) Burner Pipe
FIGURE 3
CS/CA Burners
10-32 bolts
ASSEMBLY
STEP ONE: BURNER PAN FITTINGS (Figure 1)
NOTE:
If fittings do not come pre-wrapped with Teflon threaded tape, pipe compound must be applied to the non-flared
threads.
1. Ensure
that
the
BURNER PLUG
(Figure 1A.) is inserted into the opposite end of the
BURNER PIPE
(Figure 1B)
and wrench tightened.
2. Thread the Natural Gas or Propane Burner Pan Inlet Assembly into the
BURNER PAN
(Figure 1C).
•
Natural Gas Burners (NG)
(F, FX, CS, CXF, TNA) Insert the
BURNER ORIFICE
(Figure 1D) into the
INTERNALLY
TAPPED 3/8 FLARED x 3/8 MIP ELBOW
(Figure 1E) and wrench tighten. (Orifices and Fittings are provided with the
Burner Pan
)
•
Propane Burners (LP)
(FA, FA-X, CA, CXFA, TNA/LP) requires
MA
(Figure 1F) or
MA-2
(Figure 1G)
AIR MIXER
ASSEMBLY.
Insert the Internally Tapped 3/8 Flared x 3/8 MIP Elbow and wrench tighten. Thread the Air Mixer onto
the 3/8 Flared x 3/8 MIP Elbow and wrench tighten with air intake hole positioned horizontally and parallel with the floor.
A) Burner Plug
B) Burner Pipe
C) Burner Pan
E) Internally Tapped 3/8 Flared x 3/8
MIP Elbow
FIGURE 1
G) Air Mixer For CA Burner Inlet Assembly (MA)
(Supplied with burner only)
F) Air Mixer For LP Gas Burner Inlet Assembly (MA2)
D) Orifice
Propane Burner
Inlet Assembly
Natural Gas Burner
Inlet Assembly
A) Pilot Thermocouple Assembly
Pilot
Thermocouple
Assembly