ATTENTION
READ THESE INSTRUCTIONS
CAREFULLY BEFORE ASSEMBLY
REQUIRED TOOLS AND MATERIALS:
Screw Driver, Adjustable Wrench, Pipe Wrench, Pipe
Sealing Compound, Matches.
PREPARATION:
1. This Gas Log set must be INSTALLED IN A FULLY VENTED
METAL OR MASONRY FIREPLACE WITH A WORKING FLUE
THAT IS SAFE FOR BURNING A WOOD FIRE. The Flue MUST
BE FREE OF ANY OBSTRUCTIONS.
2. Turn off gas supply to fireplace.
3. Clean fireplace floor of any ashes.
4. Attach damper clamp over edge of fireplace damper blade as shown at
Figure 1. When installed properly, damper clamp prevents accidental full
closure of damper. If unable to install provided damper clamp, consult
IMPORTANT INFORMATION on front page of these directions.
Damper Stop
Clamp
Damper
Chimney
Flue
Figure 1
STEP ONE: Burner Pan Assembly.
Attaching Burner Pan Legs (All Applications)
B
INSIDE
PAN
C
D
Figure 2
A
1.
Place F I B E R W A S H E R ( B ) onto BOLT (A). Insert BOLT (A)
with FIBER WASHER (B) through the pre-drilled hole in LEG (C).
2.
Attach L E G ( C ) through pre-drilled hole at outside-bottom corner
of BURNER PAN with NUT (D). Wrench tighten NUT (D) securely
to ensure mechanical strength and a tight gas seal. Repeat for all four
legs. See Figure 2.
N O T E : In extremely low fireplaces or where andirons are being
used, the L E G S may be left off. H O W E V E R , T O P R E V E N T
G A S L E A K I N G B E N E A T H T H E B U R N E R P A N , T H E N U T -
B O L T A N D F I B E R WASHER
MUST
BE INSTALLED TO
ENSURE GAS TIGHT INTEGRITY.
Standard Match Lighted
• (For use only with Natural Gas Models CS, CS-W)
WARNING: A SAFETY PILOT MUST BE
INSTALLED ON ALL UNITS DESIGNED
OR CONVERTED TO BURN
P R O P A N E / L P G A S
1.
Apply pipe compound to threaded end of 3/8"
FLARED BRASS ELBOW (A). Do not apply pipe
compound to flared end. Thread into BURNER PAN
INLET (B) and wrench tighten. See Figure 3
A
B
Figure 3
Accessory Match Lighted Manual V17B Valve
• (For use only with Natural Gas Models CS, CS-W)
WARNING: A SAFETY PILOT MUST BE
INSTALLED ON ALL UNITS DESIGNED
OR CONVERTED TO BURN
P R O P A N E / L P G A S
A
B
C
Figure 4
BURNER INLET
Figure 5
A
ON
OFF
.
1. Apply pipe compound to the 3/8" inlet threads of V - 1 7 V A L V E ( A ) body. Thread
brass C O N N E C T O R F I T T I N G ( B ) onto inlet threads of V - 1 7 V A L V E ( A ) body and
wrench tighten. Insert VALVE HANDLE (C) over V-17 VALVE STEM. See Figure 4 .
2. Apply pipe compound to the 3/8" outlet threads of V-17 VALVE (A) body. Thread into
BURNER INLET and wrench tighten. See Figure 5.
3
f i r e - p a r t s . c o m
