6
Mounting Toilet
Mounting surface must be flat and solid.
1.
Install seat on toilet (FIG 1).
2.
Remove motor cover.
3.
Place toilet where it will be located.
Make sure there is room to route hoses.
Make sure seat will open properly (FIG 2).
4.
Mark location of toilet base mounting holes on
mounting surface (FIG 1).
5.
Drill holes for toilet mounting bolts/screws.
NOTE:
Hole size will depend on type of bolt/screws
used (5/16” [8 mm] size bolts/screws are recommended).
6.
Secure toilet to surface
Additional Parts Required
•
Four stainless steel mounting bolts or lag screws
(minimum 1/4” [6mm]) and washers.
• 1” (25mm) or 1 1/2” (38mm) I.D. discharge hose.
•
3/4” (19mm) for seawater models or 1/2” (13mm)
for freshwater models, reinforced intake hose.
•
Hose clamps (two for each connection below
waterline).
•
Wire.
•
Terminals.
•
Fuse/circuit breaker.
Parts
Included
All Complete Toilets
Toilet
Bowl
Seat
and
Cover
Lower Base Assembly
Motor
Cover
1 1/2 (38mm) 90° Discharge fitting
Adapter, 1” FPT x Barb
Control
Sea Water Model
Intake
Pump
3/4” Hose Barb - straight fitting (2)
3/4” Hose Barb - 90° fitting
Plug Fitting
90° Rotation of Toilet Bowl
Toilet bowl can be rotated 90° on the base, for installing in
confined locations (FIG 3).
1.
Determine which direction bowl is to be mounted.
2.
Remove four vinyl caps at the base of toilet bowl.
3.
Remove four nuts and shoulder washers.
4.
Carefully remove toilet bowl from base.
5.
Rotate toilet bowl to desired position.
6.
Replace four shoulder washers, nuts and vinyl caps.
NOTE:
Tighten nuts carefully and evenly. Do
Not over tighten.
Install the Warning Label (L322) where it can be easily
seen.
Mounting In-Line Strainer
(Seawater Models Only)
Make sure strainer bowl is tight.
1.
Locate strainer where it will be accessible.
2.
Mark and drill mounting holes.
NOTE: Hole size will depend on type of bolts/screws used
(1/4” [6mm] size bolts/screws are recommended).
3.
Install fittings provided (PLA14) on strainer’s inlet and
outlet ports.
NOTE: Use thread sealant.
4.
Mount strainer. Hoses must be installed according to flow
marking on strainer top.
Mounting Remote Intake Pump
(Remote Pump Models Only)
1.
Remote intake pump must be mounted on a flat solid surface
in an area that is dry and well ventilated.
2.
Mark and drill mounting holes.
NOTE: Hole size will depend on type of bolts/screws used
1 /4” [6mm] size bolts/screws are recommended).
3.
Mount pump. Do not over tighten bolts.
INST
ALLA
TION
Tools Required
•
5/16” nut driver, wrench or screw driver.
• 5/8” (16mm) drill bit, bit for drilling mounting surface,
wire cutters, wire terminal crimpers, hose cutters, tape
measure.
L365v0320jlc
FIG 1
FIG 2
FIG 3
