Raritan PX3TS, User Manual, Page: 670 / 842

Chapter 8: Using the Command Line Interface
646
-- OR --
# reset activeEnergy outlet <outlet_n> /y
If you entered the command without "/y", a message appears prompting
you to confirm the operation. Type y to confirm the reset or n to abort it.
Variables:

<n> is the inlet number.

<outlet_n> is an outlet number.
Note: The outlet active energy reset feature is only available for
models with outlet switching.
Resetting to Factory Defaults
The following commands restore all settings of the PX3TS device to
factory defaults.
To reset PX3TS settings after login, use either command:
# reset factorydefaults
-- OR --
# reset factorydefaults /y
To reset PX3TS settings before login:
Username: factorydefaults
See
Using the CLI Command
(on page 703) for details.
Network Troubleshooting
The PX3TS provides 4 diagnostic commands for troubleshooting network
problems:
nslookup, netstat, ping, and traceroute. The diagnostic
commands function as corresponding Linux commands and can get
corresponding Linux outputs.
Entering Diagnostic Mode
Diagnostic commands function in the diagnostic mode only.
To enter the diagnostic mode:
1. Enter either of the following modes:

Administrator mode: The # prompt is displayed.

User mode: The > prompt is displayed.